ESC125S silent modular contactor 25 A, 1NO, 230 V
Silent modular contactor for remote switching of single-phase circuits. Rated current 25 A, 230–230 V AC coil and operating voltage, 1 normally open c...
Категорія
ETIMAT P10 1p C2
Номінальний струм (A)
2A
Характеристика спрацювання
C
Кількість полюсів
1
Вимикаюча здатність (кА)
10kA
Тип напруги
AC
Номінальна імпульсна напруга Uimp (kV)
6kV
Номінальна напруга AC (В)
240V
Code: 1901024
Автоматичний вимикач серії ETIMAT P10 призначений для захисту електричних кіл від перевантаження та короткого замикання. Має 1 полюс, номінальний струм 2A, характеристику C та вимикаючу здатність 10kA.
324.48 ₴
On Order
Delivery across Ukraine within 5 days from the purchase date.
Pay for orders via Liqpay and plata by mono services.
100% certified products. Service and support.
The ETIMAT P10 series automatic circuit breaker from ETI is intended for protecting electrical circuits against overload and short-circuit conditions in AC networks. It is used in distribution boards of residential, administrative, and small commercial facilities where controlled disconnection of a line is required when the permissible operating current is exceeded. With a single-pole design, the device is suitable for protecting one phase conductor in a circuit.
The rated current of 2 A makes this model appropriate for low-load circuits, including auxiliary and control lines. The C tripping characteristic means the breaker can operate in circuits with moderate inrush currents, where brief current peaks should not cause unwanted tripping. This is important for applications where electrical equipment may draw a higher current for a short time during start-up. The breaking capacity of 10 kA indicates the ability to interrupt fault current under significant short-circuit conditions, which is a key parameter for circuit protection.
The device is designed for operation in AC systems with a rated voltage of 240 V and a rated frequency of 50/60 Hz. The rated impulse withstand voltage Uimp is 6 kV, which reflects resistance to short-term impulse overvoltages. These electrical characteristics make the breaker suitable for use in standard low-voltage installations where stable operation and compliance with network parameters are required.
For installation, the breaker is intended for modular switchboard mounting and fits common distribution panel layouts. This makes it convenient for organized assembly alongside other modular devices. The supported conductor cross-section range of 1–25 mm² simplifies wiring and allows connection of conductors within the specified limits. The product complies with EN/IEC 60898, the standard governing circuit breakers for household and similar installations. Overall, this model combines a 1-pole configuration, 2 A rated current, C characteristic, 10 kA breaking capacity, AC operation, 240 V rated voltage, 6 kV impulse withstand voltage, and 50/60 Hz frequency for circuit protection in compact electrical distribution systems.
Категорія
ETIMAT P10 1p C2
Номінальний струм (A)
2A
Характеристика спрацювання
C
Кількість полюсів
1
Вимикаюча здатність (кА)
10kA
Тип напруги
AC
Номінальна імпульсна напруга Uimp (kV)
6kV
Номінальна напруга AC (В)
240V
Номінальна частота (Hz)
50Hz/60Hz
Номінальний перетин
1mm²-25mm²
Стандарт
EN/IEC 60898
Призначення
Автоматичний вимикач
0 reviews
No reviews for this product yet. Be the first!